Ganesh,
The displays you have posted don't demonstrate anything helpful. You have to determine if your material and plant are actually included in any active integration models.
Use CFM5; select 'material', select 'plants', enter your material and plant; execute.
In the subsequent display, Select Material Master Data Select the row on the right, select 'models'. At the bottom it will tell you which of your integration models contains your material, and whether or not it is active (active is green check; inactive is red x).
Repeat for plants.
During troubleshooting, you want to see one and only one active IM for your material, and one and only one active IM for your plant. If none are active, then manually activate the most recent IM. CFM2. Watch for errors during manual activation. If any FIX THESE IMMEDIATELY. During your troubleshooting, there should be one active model for the material, and one active model for the plant. If you have multiple active IMs for this material, or multiple active IMs for this plant, Inactivate and delete; such that you have one active Material IM for this material and one active plant IM for this plant. Once your problem is solved, you can recreate as many IMs as you want (although it is always a good practice to have only one active IM for any given CIF object).
Once you have successfully activated the appropriate models, without experiencing any errors, go into your SCM system and look for the Location master (the plant). /SAPAPO/LOC3. If the plant exists, then look for the Product Master. /SAPAPO/MAT1. If either doesn't yet exist, go back into ECC and run RIMODINI program against the active IM for the plant, and then again against the active IM for the material. If any errors, FIX THESE IMMEDIATELY. Rerun RIMODINI against these models until you get an error free execution.
Retry your Sales order creation after the Product master exists in SCM.
Best Regards,
DB49